zinwell zat970a user manual PDF Download

Get the zinwell zat970a user manual PDF Download HERE!

Connect the Antenna or Cable to the Receiver RF Input port using a coaxial RF cable.
Select AV or RF connection to your TV.
Connect the “VIDEO OUT” and “AUDIO OUT” to the “AV INPUT” jack on your TV using RCA type
cables. If you choose this AV connection, you need to set your TV to “AV”, “Video” input source
etc.
Or connect the RF OUT to the RF IN jack on your TV by using a coaxial RF cable. Under
the RF connection, switch your TV’s channel number to channel 3 or channel 4. (Refer to the TV
System operation through OSD Setup/ TV System item in page 6 of user’s manual).
* ZAT-970A supports Analog Pass Through function.
Proceed to select RF through of RF Output OSD item to watch the analog channels on your TV
when the STB power is on. Then switch your TV to the suitable RF input source and select analog
channel by your TV’s remote control. Refer to your TV’s manual for details.
Note: It’s normal to see the analog program with the video artifacts when you turn the STB off. The
signal loss will become more seriously without the power supply, so we highly recommend users
to operate Pass through function in power on mode.
Plug the supplied power cord from DC IN jack into a power outlet.